Amana Tool Router Bits - Flush Trim with Ball Bearing Guide

Flush Trim Router Bits with Ball Bearing Guide
2 Flute
Use any of the flush trimming bits below for laminate work or for template and pattern work. For template application, the bearing follows the template, while the cutting edges trim the workpiece. With the router handheld, the template is on the bottom of the work. With a table-mounted router, the template is on top. A two-flute bit is a good general-purpose choice, providing fast cuts and good finishes. Excellent for template work.

Tool No.

1/4

1/2

1/4

2-1/4

47090*

1/4

2-1/2

47092*

3/8

1/4

2-5/8

47100

3/8

1/2

3-1/8

47101

3/8

1/2

1/4

2-1/8

47102

3/8

2-7/8

47103†

1/2

1/4

2-5/8

47104

1/2

13/16

1/4

2-5/16

RC-47104•

1/2

1/4

2-1/4

47106

1/2

3-1/4

47108

1/2

2-3/4

47110

1/2

3/8

2-7/8

47112

3/4

1/2

3-1/4

47140

3/4

1-1/4

1/2

3-1/2

47141

*1/4" diameter for closer inside corner cutting only; bearings not guaranteed due to size.
Replacement Bearings: *1/4" dia. use #47723, 3/8" dia. use #47702,
1/2" dia. use #47706, 3/4" dia. use #47714.
Undersized bearing (.492" dia.), use #47715 - for use after re-sharpening (1/2" dia. only).
† Single Flute, for the RV industry.
• Replacement Knife #RCK-262 (2 Required)

For an extremely smooth finish, choose the three-flute configuration. It is especially good to use on laminates that tend to chip easily.

3 Flute

Tool No.

1/2

1/4

2-5/8

47114

1/2

1/4

47116

1/2

47118

1/2

3-5/8

47118-2••

1/2

2-5/8

47120

Standard replacement bearing (.500" dia.), use #47706.
Undersized bearing (.492" dia.), use #47715 - for use after re-sharpening.
••Durable ball bearing for added stability.

For a super-smooth cut finish, use a four-flute bit. Feed rate is reduced, and chipping is virtually eliminated.

4 Flute

Tool No.

3/4

1/2

57184

3/4

1-1/2

1/2

57185

3/4

1/2

4-1/2

57186

Standard replacement bearing (steel) use #47714.
Optional Delrin® replacement bearing (steel) use #47709, for solid surface application.