Flash plugin required. Download plugin here

Homepage > Router Bits > Profiling > Round Over Router Bits

Round Over Router Bits

2 Flute

This bit creates a flat-bottom groove between two quarter-round shapes. Short vertical walls extending below the radius lend extra depth to the appearance. Depending upon the cut depth adjustment, the radii can be flush with the work surface or recessed. The profile can be formed on an edge using an edge guide or, on the router table using a fence.

View Round Over Groove Elongated Plunge Router Bits

	øD	D1	R	B	B1	ød	L	Tool No.
	3/4	.240	1/4	1/2	3/8	1/2	2	49700
	.615	.240	3/16	1/2	3/16	1/2	2-1/8	49701
	7/8	.245	5/16	9/16	7/16	1/2	2-1/16	49702
	1	.250	3/8	5/8	15/32	1/2	2-1/8	49704
	1-3/8	.363	1/2	1	3/4	1/2	2-1/2	49706
14!	1-3/4	.500	5/8	1-1/4	1	1/2	2-3/4	49708*
14!	2	.500	3/4	1-7/16	1-1/8	1/2	2-15/16	49710*

Warning: Maximum RPM 14! = 14,000

NOTE: USE IN A TABLE MOUNTED ROUTER. NOT FOR USE IN A HAND HELD ROUTER!

Round Over Groove Elongated Plunge

2 Flute - Extra Deep

Proportion alone distinguishes this bit from the series above. This one cuts a deep, 1/2-inch-wide groove with small-radius shoulders. It can be used in a handheld or table-mounted routers; the cut must be guided by an edge-guide or fence.

round over groove elongated Plunge router bit

øD	D1	R	B	B1	ød	L	Tool No.
7/8	1/2	1/8	1-1/4	3/8	1/2	2-1/2	49720
1-3/16	1/2	1/4	1/2	1-3/8	1/2	2-3/8	49722
1-11/32	1/2	5/16	9/16	1-1/2	1/2	3	49724

NOTE: USE IN A TABLE MOUNTED ROUTER. NOT FOR USE IN A HAND HELD ROUTER!