Saw Blade Re-Boring Service Amana Tool Saw Blades

For special boring requests (pin-holes, keyways, etc.) please provide a detailed drawing showing bore specifications and arrangement.

Example
Picture shown >

Saw Blade
#DT305T481-30

Main Bore
30MM diameter

Pin-holes
10MM diameter each

Pin-holes location
30MM from center of main bore to center each pin-hole (60MM circle).

Delivery
Please allow 7-10 working days to process yur order.

Saw Blade Guarantee
Saw blades carry the same Amana Tool® quality guarantee. However, blades are not returnable once re bored exept for defects in material or workmanship.

Order #	Bore Range
Bore	-0- through 1-3/4"
Bore-1	Above 1-3/4" through 2"
Bore-2	Above 2" through 3"
Bore-M	Metric sizes through 75MM
Bore-3	Dado sets (6pc.) through 1-3/4" (45MM)
*Bore	Adjustable scoring sets through 30MM
Larger sizes available on request.
IMPORTANT NOTE: *Due to the many different size scoring saw arbors on the market, please order carefully. For example: If you were to assume that the arbor hole needed was 1-3/16" (1.187") and it was actually 30MM (1.181"), the difference of only .006" (6/1000th of one inch) is enough that the blade would not fit onto the arbor properly. (1-3/16" is too large to fit on 30MM arbors and will have excessive vibration and run-out and will not run concentrically.) Conversely, if the arbor hole is too small, you could do damage to the arbor, blade & tensioning if you attempt to force the blade onto the arbor.