Round Over Groove Router Bits
49703 Carbide Tipped Plunging Round Over 1/4 Radius x 3/4 Dia x 31/64 x 1/4 Inch Shank
#49703
| Diameter (D) | 3/4 |
|---|---|
| D1 | 1/4 |
| Radius (R) | 1/4 |
| Cutting Height (B) | 31/64 |
| B1 | 23/64 |
| B2 | 7/64 |
| Shank (d) | 1/4 |
| Overall Length (L) | 1-39/64 |
| Flutes | 2 |
This bit creates a flat-bottom groove between two quarter-round shapes. Short vertical walls extending below the radius lend extra depth to the appearance. Depending upon the cut depth adjustment, the radii can be flush with the work surface or recessed. The profile can be formed on an edge using an edge guide or, on the router table using a fence.
Product Questions
What would be the recommended speed feed and depth of cut? cutting white oak.
Question by: Michael Kinas on Oct 12, 2020, 6:02 PM
A good starting point would be 17,000 RPM at a feed rate of 50 inches per minute and a chip load of 0.002 per tooth at ¼” depth per pass. You should watch your cut finish and adjust in 10% increments up and or down your feed and or speed rate to achieve your desired cut finish. Remember if it is burning you are going too slow. If you want to go deeper remember to adjust your machine also.
Answer by: Amana Admin on Oct 12, 2020, 6:58 PM
OTHER SIZES AVAILABLE
