Bowl & Sink Trim Router Bits with Ultra-Glide Ball Bearing Guide
57154 Carbide Tipped Sink and Trim with Ultra-Glide Ball Bearing Guide Solid Surface 3/4 Dia x 1 Inch x 1/2 Shank
#57154
Diameter (D) | 3/4 |
---|---|
Cutting Height (B) | 1 |
Shank (d) | 1/2 |
Overall Length (L) | 3-1/2 |
Type | Flush Trim |
Replacement Bearing | 47709 |
Flutes | 2 |
Trim a sink cutout flush with the bowl in stages using these "over-hang" and flush trim bits in tandem. The overhang bits are equipped with non-marring Ultra-Glide™ bearings that are tapered to match the slope of the bowl's side. A first pass with the appropriate overhang bit cleans the cutout edge, leaving a very slight overhang at the underside of the counter. A pass with the flush-trim bit completes the operation.